Skip to main content

Full text of "Motorola V276 Repair Manual"

See other formats


Installing Motorola V276 Keypad 



iiixit 



Installing Motorola V276 Keypad 



Tools used in this guide 

• Your Hands 



© 2010 iFixit — CC BY-NC-SA www.iFixit.com Page 1 of 6 



Installing Motorola V276 Keypad 




Step 1 - Battery 

• Locate the silver button near the bottom of the back of 
your phone. 

• Press the button with one hand while sliding the back 
cover of the phone away from the antenna. 

• The back cover should slide off easily. 




Step 2 

• Insert the spudger near one corner of the battery 
(preferably one furthest from the phone's antenna). 

• With a firm grip, gently lift the end of your tool up. The 
battery should easily raise out of its place. 

• Now that the battery is easy to get a hold it, use your 
hands to take the battery out of the phone. 



©2010 iFixit — CC BY-NC-SA 



www.iFixit.com 



Page 2 of 6 



Installing Motorola V276 Keypad 




Step 3 

• Note the metal connections on the phone, which are 
now exposed with the battery removed. 

• There are corresponding metal connectors on the 
replacement battery. 

• When you install the battery, be sure both connectors 
are matched up. Otherwise, your battery will be unable 
to supply power to your phone. 




Step 4 - Motherboard 

• Use Spudger to remove rubber plug from upper left 
corner of the back of the phone 



©2010 iFixit — CC BY-NC-SA 



www.iFixit.com 



Page 3 of 6 



Installing Motorola V276 Keypad 




Steps 

• Using a Hex T6 screwdriver, remove the 4 screws 
holding the back plate of the phone in place 




Step 6 

• There will be three tabs holding the back plastic plate in 

• To remove the back plate, pull the tabs towards the 
outside of the phone and lift the plate up simultaneously 

• Be careful when removing the back plate; 
don't put too much stress on the back plate 
or the plastic may snap 



A 



©2010 iFixit — CC BY-NC-SA 



www.iFixit.com 



Page 4 of 6 



Installing Motorola V276 Keypad 




Step? 

• Remove the flex from the mother board using the 
Spudger 

• Be delicate while removing the ribbon cable 
because it is slightly fragile and it is 
necessary for the phone to function 



A 




Steps 

• Gently peel back the motherboard from the main part of 
the phone. 



© 2010 IFIxit — CC BY-NC-SA 



www.iFixit.com 



Page 5 of 6 



Installing Motorola V276 Keypad 




Step 9 - Keypad 

• Peel back keypad starting from the top of the phone 

• You can clean or replace the keypad once you have 
removed it from the phone 



©2010 iFixit — CC BY-NC-SA 



www.iFixit.com 



Page 6 of 6